Template:Networking trb manual static routes: Difference between revisions
No edit summary |
|||
Line 112: | Line 112: | ||
</tr> | </tr> | ||
</table> | </table> | ||
[[Category:{{{name}}}<nowiki> WebUI]]</nowiki> |
Revision as of 15:05, 22 November 2019
Summary
Static routes specify over which interface and gateway a certain host or network can be reached. This chapter is an overview of the Static Routes page in {{{name}}} gateways.
The information in this page is updated in accordance with the [[Media:{{{fw_version}}}.bin|{{{fw_version}}}]] firmware version.123
Static routes
To find information on static route configuration, refer to the figure and table below:
[[File:{{{file_routes}}}]]
Field | Value | Description |
---|---|---|
Interface | mobile | lan; default: mobile | The zone where the target network resides |
Target* | ip4; default: 0.0.0.0 | The address of the destination network |
Netmask* | netmask; default: 255.255.255.255 | A Mask that is applied to the Target to determine to what actual IP addresses the routing rule applies |
Gateway | ip; default: none | Defines where the router should send all the traffic that applies to the rule |
Metric | integer; default: 0 | The metric value is used as a sorting measure. If a packet about to be routed fits two rules, the one with the lower metric is applied. |
MTU | integer [64..9000]; default: 1500 | Sets the maximum transmission unit (MTU) size. It is the largest size of a protocol data unit (PDU) that can be transmitted in a single network layer transaction. |
Route Type | unicast | local | broadcast | multicast | unreachable | prohibit | backhole | anycast | -- custom -- ; default: unicast | Selects route type. Each type specifies a different behavior for the route:
|
*Additional notes on Target & Netmask:
You can define a rule that applies to a single IP like this:
- Target: some IP
- Netmask: 255.255.255.255
Furthermore, you can define a rules that apply to a range of IPs. Refer to the table below for examples.
Target | Netmask | Description |
---|---|---|
192.168.2.0 | 255.255.255.240 | Applies to IPs in the 192.168.2.0 - 192.168.2.15 range. |
192.168.2.240 | 255.255.255.240 | Applies to IPs in the 192.168.2.240 - 192.168.2.255 range. |
192.168.2.161 | 255.255.255.0 | Applies to IPs in the 192.168.2.0 - 192.168.55.255 range. |
192.168.0.0 | 255.255.0.0 | Applies to IPs in the 192.168.0.0 - 192.168.255.255 range. |
192.168.2.161 | 255.255.255.255 | Only applies to 192.168.2.161. |
[[Category:{{{name}}} WebUI]]