Template:Networking trb manual static routes

From Teltonika Networks Wiki


Static routes specify over which interface and gateway a certain host or network can be reached. This chapter is an overview of the Static Routes page in {{{name}}} gateways.

The information in this page is updated in accordance with the [[Media:{{{fw_version}}}.bin|{{{fw_version}}}]] firmware version.123

Static routes

To find information on static route configuration, refer to the figure and table below:


Field Value Description
Interface mobile | lan; default: mobile The zone where the target network resides
Target* ip4; default: The address of the destination network
Netmask* netmask; default: A Mask that is applied to the Target to determine to what actual IP addresses the routing rule applies
Gateway ip; default: none Defines where the router should send all the traffic that applies to the rule
Metric integer; default: 0 The metric value is used as a sorting measure. If a packet about to be routed fits two rules, the one with the lower metric is applied.
MTU integer [64..9000]; default: 1500 Sets the maximum transmission unit (MTU) size. It is the largest size of a protocol data unit (PDU) that can be transmitted in a single network layer transaction.
Route Type unicast | local | broadcast | multicast | unreachable | prohibit | backhole | anycast | -- custom -- ; default: unicast Selects route type. Each type specifies a different behavior for the route:
  • unicast -
  • local - routes of this type are added to the 'local' routing table and used only for locally hosted IPs.
  • broadcast - routes of this type are added to the 'local' routing table and used by link layer devices that support the broadcast address principle.
  • multicast -
  • unreachable -
  • prohibit - used to prohibit traffic to specified host or network. When a destination is prohibited, the kernel sends a 'Network is unreachable' response the source address.
  • blackhole - packets that match this type of route are discarded without any response.
  • anycast -
  • -- custom -- -

*Additional notes on Target & Netmask:

You can define a rule that applies to a single IP like this:

  • Target: some IP
  • Netmask:

Furthermore, you can define a rules that apply to a range of IPs. Refer to the table below for examples.

Target Netmask Description Applies to IPs in the - range. Applies to IPs in the - range. Applies to IPs in the - range. Applies to IPs in the - range. Only applies to