Difference between revisions of "RUT955 Inverting Relay Output Polarity"
From Teltonika Networks Wiki
(Created page with "In some cases you might want to make RUT955's relay default state ''high''. The problem is that when you reboot the router the router's relay goes back to its default state ('...") |
(Created page with "In some cases you might want to make RUT955's relay default state ''high''. The problem is that when you reboot the router the router's relay goes back to its default state ('...") |
(No difference)
|
Latest revision as of 13:09, 12 June 2020
Main Page > RUT Routers > RUT955 > RUT955 Hardware Application Examples > RUT955 Inverting Relay Output PolarityIn some cases you might want to make RUT955's relay default state high. The problem is that when you reboot the router the router's relay goes back to its default state (low) for a short period of time. In this case if you want to constantly keep it in high' state you could connect your load like shown in the picture below:
For further information about relay control refer to this page: http://wiki.teltonika-networks.com/index.php?title=Input/Output