Difference between revisions of "RUT955 Current Measurement with Analog Input"
From Teltonika Networks Wiki
(Created page with "If you want to measure the current with RUT955 you need to connect a resistor as shown in the picture below. Note that voltage on pin 9 must never exceed 24V. File:Rut955 a...") |
(Created page with "If you want to measure the current with RUT955 you need to connect a resistor as shown in the picture below. Note that voltage on pin 9 must never exceed 24V. File:Rut955 a...") |
(No difference)
|
Latest revision as of 13:12, 12 June 2020
Main Page > RUT Routers > RUT955 > RUT955 Hardware Application Examples > RUT955 Current Measurement with Analog InputIf you want to measure the current with RUT955 you need to connect a resistor as shown in the picture below. Note that voltage on pin 9 must never exceed 24V.
Configure resistor value and analog input name in the router's WebUI (see here).
This is commonly used with 4-20mA standard sensors. If your sensor has linear characteristics, you can also configure a sensor slope and offset to directly get measured values.