RUT300 LEDs: Difference between revisions

Latest revision as of 14:22, 6 April 2022

This page contains information the different types of LEDs and their behaviour on a RUT300 device.

The power LED is located on the bottom left corner of the front panel, just under the power connector.

It indicates whether the device is powered on or not.

State	Description
LED turned on	Device is powered on.
LED turned off	Device is not powered on.

There is one LEDs located at the top-left of each Ethernet port (top-right green port is unused).

They provide information on the current states of the Ethernet ports. Each port has one LED:

Below is an explanation on the behaviours of orange LEDs.

State	Description
LED on	A data connection on the port is operational (cable plugged in, end device visible, no data is being transferred).
LED off	No data connection on the port is operational (no cable, bad cable or end device not visible for some other reason (such as damaged network card)).
LED blinking	Connection established and data is being transferred over this port.

@@ Line 2: / Line 2: @@
 <!------------------------DEVICE----------------------->
 | name        = RUT300
-| series      = RUT3
+| series      = RUT30X
 <!----------------------SEPARATORS--------------------->
 | 2g          = 0  <!-- 1 has 2G; 0 doesn't have 2G -->
 | eth         = 1  <!-- 1 has ETH; 0 doesn't have ETH -->
-| eth_leds    = 2  <!-- 1 for green; 2 for green & orange-->
+| eth_leds    = 3  <!-- 1 for green; 2 for green & orange; 3 for orange-only-->
 | mobile      = 0  <!-- 1 has mobile; 0 doesn't have mobile -->
 | mobile_leds = 0  <!-- number of mobile signal strength type LEDs -->