Setting up WAN as LAN: Difference between revisions

Revision as of 08:57, 27 March 2023

The information on this page is updated in accordance with the 00.07.4 firmware version .

This article provides a guide on how to configure WAN port as LAN. These configurations are specifically made for RUTOS devices.

Set your WebUI to Basic Mode:

Navigate to Network → LAN → edit LAN the instance:

Once there, enable the Use WAN port as LAN:

Enable the ADVANCED mode on the WebUI . This will allow you to choose from a larger variety of settings:

Navigate to Network → Interfaces → General and disable WAN and WAN6 interfaces:

Click on edit the LAN interface and once a new window pops-up go to Physical settings. There, under the Interface add eth1:

At this point, WAN port should work as LAN. Go ahead and try to swap from your to current port to WAN, you should be able to ping the router.

@@ Line 18: / Line 18: @@
 ==Alternative 2==
-Enable the '''ADVANCED mode''' on the WebUI . This will allow you to choose from a larger variety of settings.
+Enable the '''ADVANCED mode''' on the WebUI . This will allow you to choose from a larger variety of settings:
 [[File:Advanced mode.png|border|center|class=tlt-border|874x63px]]
@@ Line 25: / Line 25: @@
 [[File:WAN down.png|border|center|class=tlt-border|826x173px]]
-Click on '''edit the LAN''' interface and once a new window pops-up '''go to''' '''Physical settings'''. There, under the '''Interface''' '''add eth1'''.
+Click on '''edit the LAN''' interface and once a new window pops-up '''go to''' '''Physical settings'''. There, under the '''Interface''' '''add eth1''':
 [[File:Add eth1.png|border|center|class=tlt-border|902x265px]]