Setting up WAN as LAN: Difference between revisions
AlamNasution (talk | contribs) No edit summary |
AlamNasution (talk | contribs) |
||
| Line 24: | Line 24: | ||
[[File:Networking device configuration example wan disable wan v1.png|border|center|class=tlt-border|1000x173px]] | [[File:Networking device configuration example wan disable wan v1.png|border|center|class=tlt-border|1000x173px]] | ||
Click on '''edit the WAN''' interface and once a new window pops-up '''go to''' '''Physical settings'''. There, under the '''Interface''' '''add -- No interface --''' | Click on '''edit the WAN''' interface and once a new window pops-up '''go to''' '''Physical settings'''. There, under the '''Interface''' '''add -- No interface --''': | ||
[[File:Networking device configuration example wan wan interface v1.png|border|center|class=tlt-border|1000x465px]] | [[File:Networking device configuration example wan wan interface v1.png|border|center|class=tlt-border|1000x465px]] | ||
Click on '''edit the WAN6''' interface and once a new window pops-up '''go to''' '''Physical settings'''. There, under the '''Interface''' '''add -- No interface --''' | Click on '''edit the WAN6''' interface and once a new window pops-up '''go to''' '''Physical settings'''. There, under the '''Interface''' '''add -- No interface --''': | ||
[[File:Networking device configuration example wan wan6 interface v1.png|border|center|class=tlt-border|1000x465px]] | [[File:Networking device configuration example wan wan6 interface v1.png|border|center|class=tlt-border|1000x465px]] | ||
Revision as of 06:17, 24 January 2024
Main Page > General Information > Configuration Examples > LAN > Setting up WAN as LANThe information on this page is updated in accordance with the 00.07.6 firmware version .
Introduction
This article provides a guide on how to configure WAN port as LAN. These configurations are specifically made for RUTOS devices.
Alternative 1
Set your WebUI to Basic Mode:
Navigate to Network → LAN → edit LAN the instance:
Once there, enable the Use WAN port as LAN:
Alternative 2
Enable the ADVANCED mode on the WebUI . This will allow you to choose from a larger variety of settings:
Navigate to Network → Interfaces → General and disable WAN and WAN6 interfaces:
Click on edit the WAN interface and once a new window pops-up go to Physical settings. There, under the Interface add -- No interface --:
Click on edit the WAN6 interface and once a new window pops-up go to Physical settings. There, under the Interface add -- No interface --:
Click on edit the LAN interface and once a new window pops-up go to Physical settings. There, under the Interface add eth1:
Test the configuration
At this point, WAN port should work as LAN. Go ahead and try to swap from your to current port to WAN, you should be able to ping the router.
