DHCP Relay configuration example new: Difference between revisions
| Line 69: | Line 69: | ||
---- | ---- | ||
=====Relay LAN Confiuration===== | =====Relay LAN Confiuration===== | ||
Open | This router requires internet access. The specified settings should be activated by default. Open router’s WebUI → Network → LAN click Pencil2.pngon current available LAN interface configuration: | ||
======General Settings====== | |||
Make the following changes: | |||
# Enter IPv4 address: 192.168.2.1 | |||
Revision as of 09:52, 31 July 2024
Main Page > General Information > Configuration Examples > Router control and monitoring > DHCP Relay configuration example newThe information on this page is updated in accordance with the 00.07.08 firmware version .
firmware version .
Introduction
DHCP Relay is a router that forwards IP addresses from the DHCP Server to the user devices, even if the server is on a different network. The main benefit of this approach is that a single DHCP Server can distribute IP addresses to multiple networks. Bellow you will find an example of how to configure a basic DHCP Relay configuration.
Prerequisites & Topology
Prerequisites
- For this configuration you will need 2 routers. One as a DHCP Server and the other as a DHCP Relay.
- DHCP Relay device WAN port needs to be connected to DHCP server LAN port.
Topology
DHCP Relay network settings:
LAN IP/subnet: 192.168.2.1/24 WAN IP: 192.168.4.194
DHCP server network settings:
LAN IP/subnet: 192.168.4.1/24
Configuration
If you're having trouble finding this page or some of the parameters described here on your device's WebUI, you should turn on "Advanced WebUI" mode. You can do that by clicking the "Advanced" button, located at the top of the WebUI.
DHCP Server Node Configuration
DHCP Server LAN Configuration
This router requires internet access. The specified settings should be activated by default.
Open router’s WebUI → Network → LAN click 
on current available LAN interface configuration:
General Settings
Make the following changes:
- Enter IPv4 address: 192.168.4.1
DHCP Server Lease Configuration
Open router’s WebUI → System → Mantenance → CLI
Enter this command to CLI:
echo "dhcp-range=192.168.2.100,192.168.2.200,12h" >> /etc/dnsmasq.conf
DHCP Server Node Static Route
Open WebUI → Network → Routing → Static routes
DHCP Server Static Route
click 
and apply this to the route:
- Select Interface: lan | Enter Target: 192.168.2.0 | Enter IPv4-Netmask: 255.255.255.0 | Enter IPv4-Gateway: 192.168.4.194
DHCP Relay Configuration
Relay LAN Confiuration
This router requires internet access. The specified settings should be activated by default. Open router’s WebUI → Network → LAN click Pencil2.pngon current available LAN interface configuration:
General Settings
Make the following changes:
- Enter IPv4 address: 192.168.2.1