DHCP Relay configuration example new

The information on this page is updated in accordance with the 00.07.08 firmware version .

firmware version .

Introduction

---

DHCP Relay is a router that forwards IP addresses from the DHCP Server to the user devices, even if the server is on a different network. The main benefit of this approach is that a single DHCP Server can distribute IP addresses to multiple networks. Bellow you will find an example of how to configure a basic DHCP Relay configuration. ​

Prerequisites & Topology

---

Prerequisites

1. For this configuration you will need 2 routers. One as a DHCP Server and the other as a DHCP Relay.
2. DHCP Relay device WAN port needs to be connected to DHCP server LAN port.

Topology

---

DHCP Relay network settings:

LAN IP/subnet: 192.168.2.1/24
WAN IP: 192.168.4.194

DHCP server network settings:

LAN IP/subnet: 192.168.4.1/24

Configuration

---

If you're having trouble finding this page or some of the parameters described here on your device's WebUI, you should turn on "Advanced WebUI" mode. You can do that by clicking the "Advanced" button, located at the top of the WebUI.

DHCP Server Node Configuration

---

LAN Configuration

Open router’s WebUI → Network → LAN click on current available LAN interface configuration:

General Settings

---

Make the following changes:

1. Enter IPv4 address: 192.168.4.1

Lease Configuration

---

Open router’s WebUI → System → Mantenance → CLI

Enter this command to CLI:

echo "dhcp-range=192.168.2.100,192.168.2.200,12h" >> /etc/dnsmasq.conf

Static Route Configuration

---

Open WebUI → Network → Routing → Static routes

Static IPv4 Routes

---

click and apply this to the route:

1. Select Interface: lan | Enter Target: 192.168.2.0 | Enter IPv4-Netmask: 255.255.255.0 | Enter IPv4-Gateway: 192.168.4.194

DHCP Relay Configuration

---

Relay WAN Confiuration

Open router’s WebUI → Network → WAN → WAN interfaces click current available WAN interface configuration:

General Settings

---

Make the following changes:

1. Select Protocol: Static
2. Enter IPv4 address: 192.168.4.194

Relay LAN Confiuration

Open router’s WebUI → Network → LAN click current available LAN interface configuration:

General Settings

---

Make the following changes:

1. Enter IPv4 address: 192.168.2.1

DHCP Server Configuration

---

Open router’s WebUI → Network → DHCP → Server Settings → IPv4 → DHCPv4 servers click current available server interface configuration:

DHCPv4: lan

---

Make the following changes:

1. Enable: on
2. Select DHCPv4 mode: Relay
3. Enter DHCP server address: 192.168.2.1