Template:Networking rutos manual network

From Teltonika Networks Wiki
Revision as of 08:17, 28 September 2023 by MartynasL (talk | contribs)

Template:Networking rutos manual fw disclosure


Summary

The Network page contains information related to the device's networking. This chapter is an overview of the Network page in {{{name}}} devices.

If you're having trouble finding this page or some of the parameters described here on your device's WebUI, you should turn on "Advanced WebUI" mode. You can do that by clicking the "Advanced" button, located at the top of the WebUI.

mobile network operator (MNO). Mobile network code Mobile Network Code (MNC) is a unique two- or three-digit number used to identify a home Public Land Mobile Network (PLMN) to. MNC is allocated by the national regulator.


Bands


bands information
Name Connected band
Other signal level measurements Overall signal quality for different network types is defined by different measurements. Short explanations and recommendations are provided below. Click here for more in-depth information or click on one of the links below:
  • 4G
    • RSRP - reference signal received power, measured in dBm. Values closer to 0 indicate better signal strength
    • RSRQ - reference signal received quality, measured in dB. Values closer to 0 indicate a better rate of information transfer
    • SINR - signal-to-interference-plus-noise ratio, measured in dB. Higher values indicate a better rate of information transfer
  • 3G
    • EC/IO - downlink carrier-to-interference ratio. Values range from -20 to 0 (closer to 0 indicates better signal quality/cleanliness)
    • RSCP - received signal code power. Values range from -124 to 0 (closer to 0 indicates better signal stength)

LAN

This tab displays information about the device's local network(s). The figure below is an example of the Network window:

lan information
Name LAN interface name
IP address IP address of the LAN interface
Netmask Netmask of the LAN interface. In a sense, a netmask specifies the size of a network. In other words, it indicates which part of the IP address denotes the network, and which denotes the device
dhcp leases
Hostname Hostname of a LAN client
IP Address IP address of a LAN client
MAC Address MAC address of a LAN client
Leasetime Remaining Remaining lease time for a DHCP client. Active DHCP lease holders will try to renew their DHCP leases after a half of the lease time passes.
Static Lease This action will reserve currently assigned IP address for the device in Network -> Interfaces -> Static leases.

Firewall

This tab displays information about the device's firewall. Info is shown of IPv4 and IPv6 traffic. The figure below is an example of the Firewall page tables:

Field name Description
Name Name of the chain
Traffic Size of traffic that was matched to the chain
Packets Count of packets that were matched to the chain
Policy Policy for traffic entering the zone.
Rules Count of rules the chain has
References Count of times the chain was referenced in other chains


For more information about specific firewall chain, INFO button can be pressed. Window like this should pop up:

Field name Description
Traffic Size of traffic that was matched to the rule
Packets Count of packets that were matched to the rule
Target Name of the rule (if highlighted you can click it to open modal to it)
Protocol Filters by Internet protocol
In Filters by inbound interface
Out Filters by outbound interface
Source Filters by source address
Destination Filters by destination address
Options Additional iptables options
Comment Filters by comment



[[Category:{{{name}}} Status section]]