Domnev
The information in this page is updated in accordance with 00.07.03.4 firmware version .
Introduction
This article contains instructions on how to setup BACnet on Teltonika Networks devices.
Configuration overview and prerequisites
Before we begin, let's take a look at the configuration that we are attempting to achieve and the prerequisites that make it possible.
Prerequisites:
- RUT955;
- BACnet controller;
- Server;
- An end device (PC, Laptop, Tablet, Smartphone) for configuration;
If you're having trouble finding any page or some of the parameters described here on your device's WebUI, you should turn on "Advanced WebUI" mode. You can do that by clicking the "Basic" button under "Mode," which is located at the top-right corner of the WebUI.
Note: It is a additional software that can be installed from the Services → Package Manager page.
BACnet MS/TP configuration
Master - Slave Token Passing (MSTP) is most commonly used to connect field devices to controllers / routers / control applications. The physical layer uses RS485 which allows up to 128 devices to be installed on a single network.
BACnet
Server
For the server, Yet Another BACnet Explorer is used
Results
BACnet/IP configuration
BACnet is a communication protocol for building automation and control (BAC) networks that use the ASHRAE, ANSI, and ISO 16484-5 standards protocol.
BACnet
This is the most commonly used type of BACnet, which is designed to work over Ethernet networks using the Internet Protocol (IP). It supports both IPv4 and IPv6 addressing.
Firewall
Server
For the server, Yet Another BACnet Explorer is used
Results
See also
BACnet on RUT955