Before you start using ubus commands to control Bluetooth, make sure you have enabled it. You can do that in '''Network -> Bluetooth -> General''' settings. Click '''Enable Bluetooth''' and press '''Save & Apply'''.
+
Before you start using ubus commands to control Bluetooth, make sure you have enabled it. You can do that in '''Network → Bluetooth → General''' settings. Click '''Enable Bluetooth''' and press '''Save & Apply'''.
The scan process takes about 30 seconds. The '''"scanning": 1''' output shows us that scan still in progress. After it finishes you should see a similar output:
+
The scan process takes about 30 seconds. If you can see '''"scanning": 1''' in the output it means, that scanning is still in progress. After it finishes you should see a similar output: