Jump to content

How to use UBUS commands for Bluetooth device scanning / pairing: Difference between revisions

no edit summary
No edit summary
No edit summary
Line 6: Line 6:


----
----
Before you start using ubus commands to control Bluetooth, make sure you have enabled it. You can do that in '''Network -> Bluetooth -> General''' settings. Click '''Enable Bluetooth''' and press '''Save & Apply'''.
Before you start using ubus commands to control Bluetooth, make sure you have enabled it. You can do that in '''Network Bluetooth General''' settings. Click '''Enable Bluetooth''' and press '''Save & Apply'''.
    
    
[[File:Networking_rutx_configuration_example_bluetooth_enable_v1.png]]
[[File:Networking_rutx_configuration_example_bluetooth_enable_v1.png]]
Line 22: Line 22:
  ...
  ...


The scan process takes about 30 seconds. The '''"scanning": 1''' output shows us that scan still in progress. After it finishes you should see a similar output:
The scan process takes about 30 seconds. If you can see '''"scanning": 1''' in the output it means, that scanning is still in progress. After it finishes you should see a similar output:


  ...
  ...
0

edits