What IP addresses and ports are used by RMS?

From Teltonika Networks Wiki
Main Page > IoT Platforms > RMS > RMS FAQ > What IP addresses and ports are used by RMS?

Introduction

This article lists IP addresses and TCP/UDP ports used by the Teltonika Networks RMS.

Note: The IP addresses and ports listed in the RMS Management, RMS Connect and RMS VPN sections need to be reachable by the devices. If certain functions are not required, the de

Reaching RMS platform

Reaching the RMS webpage requires access to the following IP addresses:

  • 18.196.62.30
  • 3.77.70.198

The above IP addresses use the following ports:

Protocol Port number
TCP 80
TCP 443

RMS Management

RMS Management uses the following IP addresses:

  • 18.196.62.30
  • 3.69.112.66
  • 35.157.156.54
  • 18.157.218.160
  • 3.77.251.245
  • 3.78.70.211
  • 18.158.123.134

All of the IP addresses listed above use the following ports:

Protocol Port number
TCP 15009
TCP 15010
TCP 15011
TCP 15039
TCP 15040
Maintenance ports
15041 - 15100

RMS Connect

RMS Connect uses the following IP address: 18.192.27.240 and the ports provided in the table below.

Protocol Port number Service
TCP 20022 Remote SSH
TCP 20080 Remote HTTP(S)
TCP 20100 Remote SFTP
TCP 20120 Remote Telnet
TCP 23389 Remote Desktop

Remote mobile devices


RMS Connect - Remote mobile devices uses the following IP address: 3.66.242.160.

RMS VPN

RMS VPN uses the following IP addresses:

  • 3.69.106.81 (Germany)
  • 3.65.167.143 (Germany)
  • 15.185.110.7 (Bahrain)
  • 15.184.134.94 (Bahrain)
  • 34.230.227.9 (Eastern US - Virginia)
  • 44.205.223.152 (Eastern US - Virginia)
  • 13.238.208.90 (Australia)
  • 54.253.39.211 (Australia)
Protocol Port number
UDP Random port in the [30000-39999] range


* Although these are currently used ports, it is recommended to unblock all ports on specified IP addresses.

In most cases, access to these IP addresses shall not be an issue as usually none of the outgoing traffic is blocked.

However, where ISP blocks all non-standard ports or the SIM card is in a Private APN network/setup, you will have to inquire your ISP to allow the mentioned IP and Ports to be made available.