What IP addresses and ports are used by RMS?
Introduction
This article shows what default UDP and TCP ports are used by the Teltonika Networks RMS. For all or specific RMS functionalities to work, the device or devices must access the IPs and ports provided below.
Reaching RMS platform
To reach the RMS platform from a device in a private network would require access to the IP address 18.196.62.30 and the ports provided in the table below.
| Protocol | Port number |
|---|---|
| TCP | 80 |
| TCP | 443 |
RMS Management
RMS Management uses the following IP address: 18.196.62.30 and the ports provided in the table below.
| Protocol | Port number |
|---|---|
| TCP | 15009 |
| TCP | 15010 |
RMS Connect
RMS Connect uses the following IP address: 18.192.27.240 and the ports provided in the table below.
| Protocol | Port number | Service |
|---|---|---|
| TCP | 20022 | Remote SSH |
| TCP | 20080 | Remote HTTP(S) |
| TCP | 20100 | Remote SFTP |
| TCP | 20120 | Remote Telnet |
| TCP | 23389 | Remote Desktop |
Remote mobile devices
RMS Connect - Remote mobile devices uses the following IP address: 3.66.242.160.
RMS VPN
RMS VPN uses the following IP addresses: 3.69.106.81 and 3.65.167.143.
| Protocol | Port number |
|---|---|
| TCP | Random port in the [30000-39999] range |
* Although these are currently used ports, it is recommended to unblock all ports on specified IP addresses.
In most cases, access to these IP addresses shall not be an issue as usually none of the outgoing traffic is blocked.
However, where ISP blocks all non-standard ports or the SIM card is in a Private APN network/setup, you will have to inquire your ISP to allow the mentioned IP and Ports to be made available.