Difference between revisions of "Domnev"
| Line 30: | Line 30: | ||
[[File:IPsec HUB Connection Advanced.png|border|center|class=tlt-border|752x541px]] | [[File:IPsec HUB Connection Advanced.png|border|center|class=tlt-border|752x541px]] | ||
| + | |||
| + | [[File:IPsec Phase1.png|border|center|class=tlt-border|742x254px]] | ||
| + | |||
| + | [[File:IPsec Phase2.png|border|center|class=tlt-border|748x257px]] | ||
==RUT2 (Spoke) configuration== | ==RUT2 (Spoke) configuration== | ||
Revision as of 13:58, 20 March 2023
The information in this page is updated in accordance with 00.07.4 firmware version .
Introduction
Configuration overview and prerequisites
Before we begin, let's take a look at the configuration that we are attempting to achieve and the prerequisites that make it possible.
Prerequisites:
- Two RUT/RUTX series routers with RUTOS firmware;
- An end device (PC, Laptop) for configuration;
If you're having trouble finding any page or some of the parameters described here on your device's WebUI, you should turn on "Advanced WebUI" mode. You can do that by clicking the "Basic" button under "Mode," which is located at the top-right corner of the WebUI.
Topology
RUT1 - RUTX11 as a hub. It will be our "default gateway" for spoke device. RUTX11 has a LAN subnet of 192.168.11.0/24 configured on it, which should be reachable by the spoke.
RUT2 - RUT955 as a spoke. It will be connecting to a hub for basic internet access. RUT955 has a lan subnet of 192.168.9.0/24 configured on it, which should be reachable by the hub.
RUT1 (Hub) configuration
Start by configuring HUB (RUT1) device. Login to the WebUI, navigate to Services → VPN → IPsec and add a new IPsec instance. Configure everything as follows:
