Changes

Before you can add a new device to Teltonika's Remote Management System (RMS), you must enable '''remote monitoring for RMS''' in the router's configuration. You can do this either before or after adding the device from the RMS web page. A brief guide on how to do this is presented below:

Before you can add a new device to Teltonika's Remote Management System (RMS), you must enable '''remote monitoring for RMS''' in the router's configuration. You can do this either before or after adding the device from the RMS web page. A brief guide on how to do this is presented below:

* Open your web browser ant type in the router's LAN IP address ('''192.168.1.1''' by default) into the URL field and press the "Enter" key:

* [[How to add devices to RMS?]]

 

* [[How to add a list of devices to RMS?]]

 

[[File:Enabling remote access for rms part 2 v1.png]]

 

'''NOTE''': default login values are Username: '''admin'''; Password: '''admin01''' (this is the default password for RUT routers, but you will be prompted to change it during you first login. If this is not your first login, use the password you chose before).

* When you completed the login, navigate to the '''System''' menu and click on the '''Administration''' field:

 

[[File:Enabling remote access for rms part 3 v1.png]]

* From the Administration Settings window go to the '''RMS''' section located near the top of the page:

 

[[File:Enabling remote access for rms part 4 v1.png]]

* Place a check mark next to the "Enable remote monitoring" field"

 

[[File:Enabling remote access for rms part 5 v1.png]]

 

 

* [[How to add a new device to RMS?]]

[[Category:RMS_FAQ]]

* [[How to add multiple devices to RMS at once?]]