37
edits
Changes
IPsec RUTOS configuration example (view source)
Revision as of 13:53, 15 February 2024
, 15 Februaryno edit summary
----
----
*Click the "Edit" button located next to the newly created instance and set up the configuration according to the network:
*Click the "Edit" button located next to the newly created instance and set up the configuration according to the network:
[[File:IPsec RUT955 config 2.png|alt=|border|center|930x930px|class=tlt-border]]
[[File:RUTOS IPsec rut955 config 2.png|alt=|border|center|930x930px|class=tlt-border]]
[[File:RUTOS ipsec RUT955 optionconfig xauth 1.png|alt=|border|center|930x930px|class=tlt-border]]
[[File:RUTOS ipsec RUT955 optionconfig xauth 1.png|alt=|border|center|930x930px|class=tlt-border]]
*Below are explanations of the parameters highlighted in the figure above. Other parameters (not highlighted) are defaults. You can find descriptions for these parameters in the '''[[VPN#IPsec|VPN manual page, IPsec section]]'''
*Below are explanations of the parameters highlighted in the figure above. Other parameters (not highlighted) are defaults. You can find descriptions for these parameters in the '''[[VPN#IPsec|VPN manual page, IPsec section]]'''
***'''Ping period (sec)''' - the period (in seconds) at which ICMP packets will be sent to the specified host
***'''Ping period (sec)''' - the period (in seconds) at which ICMP packets will be sent to the specified host
**'''Allow WebUI access''' - when checked, allows WebUI access for hosts from the opposite instance
**'''Allow WebUI access''' - when checked, allows WebUI access for hosts from the opposite instance
**'''XAUTH''' - when checked, allows is used to edit and display the authorization information used in connecting to the X server
**'''XAUTH''' - note that option, available only if you choose IKEv1, when checked, allows is used to edit and display the authorization information used in connecting to the X server.
**'''IKEv2 vs IKEv1''' - use IKEv2 for better security, speed, and flexibility, especially in dynamic environments. IKEv1 is older but still widely supported in legacy systems. Choose based on specific requirements and compatibility.
**'''Local&Remote identifiers''' - there is two types, IP Adress type - which could describe certain subnet gateway like 192.168.1.1 or whole subnet like 192.168.1.0/24. Hostname type - is when IP address is subject to change, providing more flexibility, and look like - " vpngatewayname.yourdomain ".
'''NOTE''': remember to replace certain parameter values (like IP addresses) with your own relevant data.
'''NOTE''': remember to replace certain parameter values (like IP addresses) with your own relevant data.
*In this case, Remote endpoint should be RUTX11's Public IP:
*In this case, Remote endpoint should be RUTX11's Public IP:
[[File:IPsec RUTX11 Config2.png|alt=|center|930x930px|border|class=tlt-border]]
[[File:RUTOS IPsec rutx11 config 2.png|alt=|center|930x930px|border|class=tlt-border]]
[[File:RUTOS ipsec RUT955 optionconfig xauth 1.png|alt=|border|center|930x930px|class=tlt-border]]
[[File:RUTOS ipsec RUT955 optionconfig xauth 1.png|alt=|border|center|930x930px|class=tlt-border]]
----
----