Changes

LAN as WAN RutOS (view source)

Revision as of 13:34, 6 January 2022

1,183 bytes removed ,  13:34, 6 January 2022
no edit summary
Line 77: Line 77:  
Insert WAN cable in selected port, go to <strong>Network > Interfaces</strong> WebUI section and if you followed steps correctly yours newly created WAN interface should be running and have an IP.
 
Insert WAN cable in selected port, go to <strong>Network > Interfaces</strong> WebUI section and if you followed steps correctly yours newly created WAN interface should be running and have an IP.
 
[[File:Network rutos manual lan as wan check.png|border|class=tlt-border]]
 
[[File:Network rutos manual lan as wan check.png|border|class=tlt-border]]
−
  −
==Testing the configuration==
  −
  −
If everything went well, your device should now have two wired WAN connections. To test this go to the <i>Network → WAN</i> page and check if the new interface is enabled and if it has an IP address.
  −
  −
<ul>
  −
    <li>Set the Wired (WAN) interface as the main WAN connection.</li>
  −
    <li>Set the new interface as WAN failover and save the changes.<br>[[File:Networking_rutxxx_configuration_examples_use_lan_as_wan_7_v1.png|border|class=tlt-border]]</li>
  −
    <li>Go to [www.whatsmyip.com] and check your public IP address.<br>[[File:0011.png|border|class=tlt-border|960px]]</li>
  −
    <li>Then unplug the main WAN cable and check again. If the interface failed over correctly, the website should a different IP address than before.<br>[[File:0012.png|border|class=tlt-border|960px]]</li>
  −
    <li>Plug the main WAN cable back in and wait a bit. Refresh the website; the IP should have change back to the one shown in the first place.</li>
  −
</ul>
  −
  −
[[Category:-Network Control]] [[Category:RUT955 Config Examples]] [[Category:RUT950 Config Examples]] [[Category:RUT900 Config Examples]] [[Category:RUT240 Config Examples]] [[Category:RUT230 Config Examples]]
 
Retrieved from "https://wiki.teltonika-networks.com/view/Special:MobileDiff/87450"

Navigation menu