538
edits
Changes
Monitoring via Modbus (view source)
Revision as of 09:42, 12 September 2019
, 09:42, 12 September 2019→Setting router values
As you can see most of the values are '''0''' and '''1''', 0 meaning OFF and 1 meaning ON. For example, if you want to turn '''WiFi OFF''', this command should be used:
As you can see most of the values are '''0''' and '''1''', 0 meaning OFF and 1 meaning ON. For example, if you want to turn '''WiFi OFF''', this command should be used:
$ modbus write -w -p 12345 192.168.1.1 %MW210 0
$ modbus write -w -p 12345 192.168.1.1 %MW203 0
If you want to turn '''WiFi ON''', use this command instead:
If you want to turn '''WiFi ON''', use this command instead:
$ modbus write -w -p 12345 192.168.1.1 %MW210 1
$ modbus write -w -p 12345 192.168.1.1 %MW203 1
As you can see, the only difference is the digit at the end - '''0 for OFF''', '''1 for ON'''. The same is true for all other parameters that accept only two input values.
As you can see, the only difference is the digit at the end - '''0 for OFF''', '''1 for ON'''. The same is true for all other parameters that accept only two input values.
In the case of '''SIM switch''' there are three values - '''0''', '''1''' and '''2'''. 1 makes the first SIM card slot in use, 2 makes the second SIM card slot in use and 0 initiates a switc from the SIM card in use to the opposite SIM card. For example, to initiate a switch to the second SIM card the command should look like this:
In the case of '''SIM switch''' there are three values - '''0''', '''1''' and '''2'''. 1 makes the first SIM card slot in use, 2 makes the second SIM card slot in use and 0 initiates a switc from the SIM card in use to the opposite SIM card. For example, to initiate a switch to the second SIM card the command should look like this:
$ modbus write -w -p 12345 192.168.1.1 %MW212 2
$ modbus write -w -p 12345 192.168.1.1 %MW205 2
The '''reboot''' function only takes one value: '''1'''. It simply reboots the router. To initiate a reboot, use this command:
The '''reboot''' function only takes one value: '''1'''. It simply reboots the router. To initiate a reboot, use this command:
$ modbus write -w -p 12345 192.168.1.1 %MW220 1
$ modbus write -w -p 12345 192.168.1.1 %MW206 1
===APN===
===APN===