RUT230 User Scripts (legacy WebUI)

From Teltonika Networks Wiki
Revision as of 14:19, 18 November 2021 by Gytispieze (talk | contribs) (Gytispieze moved page Draft:RUT230 User Scripts (legacy WebUI) to RUT230 User Scripts (legacy WebUI) without leaving a redirect)

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)
Main Page > EOL Products > RUT230 > RUT230 Manual > RUT230 Legacy WebUI > RUT230 System section (legacy) > RUT230 User Scripts (legacy WebUI)

The information in this page is updated in accordance with firmware version RUT2XX_R_00.01.14.7.

Notice: This device has entered it's EOL (End of Life) cycle. For more information, visit our EOL policy here. Temporarily, some content in this page might not match features found in firmware listed above.

Note: this user manual page is for RUT230's old WebUI style available in earlier FW versions. Click here for information based on the latest FW version.

Summary

The User Scripts function allows users to write their own shell scripts that will be executed during the router's booting process.

This chapter of the user manual provides an overview of the User Scripts page for RUT230 devices.

Startup script management

The startup script management section shows the contents of the /etc/rc.local file and allows the user to edit it. Scripts written in this file are executed at the end of the device's start up process. You can also execute written scripts via a command line interface with the following command:

sh /etc/rc.local

The figure below is an example of the startup script management section:

Networking rutxxx manual user scripts v1.png