RUT300 Remote Monitoring & Administration
RUT300 supports multiple monitoring and administration possibilities.
Remote control options
The RUT300 router supports the following remote control capabilities:
|Remote control method||Can get parameters||Can set parameters|
The Remote Management System (RMS) is designed to conveniently monitor and manage all your Teltonika networking devices. The system allows to securely gather status information of your devices and to change their configuration even if the devices do not have public IP addresses.
RMS access can be configured from the System → Administration → RMS page.
If your device has a Public IP address (refer here for more information), you can reach the router via HTTP or SSH via its WAN IP address.
Remote HTTP access can be set up via the System → Administration → Access Control page.
Remote SSH access can be set up via the System → Administration → Access Control page.
JSON-RPC access can be set up via the System → Administration → Access Control page.
Virtual Private Networks (VPNs) provide multiple flexible options on setting up remote access to the router and its LAN network. For more information on different types of VPNs supported by RUT300, visit the VPN manual page.
Simple Network Management Protocol (SNMP) is a protocol for network management, used for collecting information from network devices. For more information on SNMP in RUT300, visit the SNMP manual page.
Modbus is a serial communications protocol used in communication with various types of industrial electronic devices. For more information on Modbus TCP in RUT300, visit the Modbus manual page.
MQTT (MQ Telemetry Transport or Message Queue Telemetry Transport) is a publish-subscribe-based "lightweight" messaging protocol for use on top of the TCP/IP protocol. For more information on MQTT in RUT300, visit the MQTT manual page
Technical Report 069 (TR-069) is a technical specification of the Broadband Forum that defines an application layer protocol for remote management of customer-premises equipment (CPE) connected to an Internet Protocol (IP) network. For more information on TR-069 in RUT300, visit the TR-069 manual page
Distributed Network Protocol 3 (DNP3) is a set of communications protocols used between components in process automation systems. For more information on DNP3 in RUT300, visit the DNP3 manual page