RUT301 Network

From Teltonika Networks Wiki
Main Page > RUT Routers > RUT301 > RUT301 Manual > RUT301 WebUI > RUT301 Status section > RUT301 Network

The information in this page is updated in accordance with firmware version RUT301_R_00.07.10.2.


Summary

The Network page contains information related to the device's networking. This chapter is an overview of the Network page in RUT301 devices.

If you're having trouble finding this page or some of the parameters described here on your device's WebUI, you should turn on "Advanced WebUI" mode. You can do that by clicking the "Advanced" button, located at the top of the WebUI.


LAN

This tab displays information about the device's local network(s). The figure below is an example of the Network window:

lan information
Name LAN interface name
Address IP address of the LAN interface
Netmask Netmask of the LAN interface. In a sense, a netmask specifies the size of a network. In other words, it indicates which part of the IP address denotes the network, and which denotes the device
dhcp leases
Interface Interface which leased the address
Hostname Hostname of a LAN client
IP Address IP address of a LAN client
MAC Address MAC address of a LAN client
Leasetime Remaining Remaining lease time for a DHCP client. Active DHCP lease holders will try to renew their DHCP leases after a half of the lease time passes.
Static Lease This action will reserve currently assigned IP address for the device in Network -> Interfaces -> Static leases.

Similarly there is an IPv6 dedicated tab.

lan information
Name LAN interface name
Address IP address of the LAN interface
Delegated prefix The delegated prefix is a smaller subnet given to a device to lease IPv6 addresses for its own DHCPv6 clients.
dhcp leases
Interface Interface which leased the address
Hostname Hostname of a LAN client
Address IP address of a LAN client
Delegated prefix The delegated prefix is a smaller subnet given to a device to lease IPv6 addresses for its own DHCPv6 clients.
DUID DHCP unique identifier is used by DHCPv6 to identify device. Similar to MAC that is used by DHCPv4.
Leasetime Remaining Remaining lease time for a DHCP client. Active DHCP lease holders will try to renew their DHCP leases after a half of the lease time passes.
Static Lease This action will reserve currently assigned IP address for the device in Network -> Interfaces -> Static leases.

Firewall

This tab displays information about the device's firewall. Info is shown of IPv4 and IPv6 traffic. The figure below is an example of the Firewall page tables:

Field name Description
Reset counters Resets all traffic and packet fields
Name Name of the chain
Traffic Size of traffic that was matched to the chain
Packets Count of packets that were matched to the chain
Policy Policy for traffic entering the zone.
Rules Count of rules the chain has
References Count of times the chain was referenced in other chains


For more information about specific firewall chain, INFO button can be pressed. Window like this should pop up:

Field name Description
Traffic Size of traffic that was matched to the rule
Packets Count of packets that were matched to the rule
Target Name of the rule (if highlighted you can click it to open modal to it)
Protocol Filters by Internet protocol
In Filters by inbound interface
Out Filters by outbound interface
Source Filters by source address
Destination Filters by destination address
Options Additional iptables options
Comment Filters by comment

Topology

The Topology tab allows scanning of WAN, LAN or both interfaces via arp scan to check active connected devices. After scan it shows how many active devices were found and on which interface.

All active devices

This section displays the results of the scan.

field name description
Hostname (Vendor) Hostname of scanned device
IP Address IP address of scanned device
MAC Address MAC address of scanned device
Type The type of connection
Interface The interface the scanned device is connected