RUT850 Graphs

From Wiki Knowledge Base | Teltonika Networks
This is the approved revision of this page, as well as being the most recent.
Main Page > RUTxxx Routers > RUT850 > RUT850 Manual > RUT850 WebUI > RUT850 Graphs

Summary[edit | edit source]

The Graphs section contains various graphs that display various statistical data changes in real time. This chapter is an overview of the Graphs section in RUT850 routers.

The information in this page is updated in accordance with the [[Media:{{{fw_version}}}_WEBUI.bin|{{{fw_version}}}]] firmware version.

Mobile Signal[edit | edit source]

The Mobile Signal Strength graph displays mobile signal strength (RSSI, measured in dBm) value changes over a period of 3 minutes. The figure below is an example of the Mobile Signal Strength graph:

Rut850 webui status graphs mobile signal mobile signal strength v1.png

Load[edit | edit source]

The Realtime Load section displays a tri-graph that illustrates average CPU load values in real time. The graph consists out of three color coded graphs, each one corresponding to the average CPU load over 1 (red), 5 (orange) and 15 (yellow) most recent minutes.

The figure below is an example of the Realtime Load graph:

Rutxxx webui status graphs load realtime load v1.png

Traffic[edit | edit source]

The Realtime Traffic graphs provide users with the possibility to monitor average inbound and outbound traffic over the course of 3 minutes; each new measurement is taken every 3 seconds. The graphs consist out of two color coded graphs: the green graph shows the outbound traffic, the blue graph shows the inbound traffic. Although not graphed, the page also displays peak loads and averages of inbound and outbound traffic.

The figure below is an example of the Realtime traffic graph for the Bridge connection:

Rut850 webui status graphs traffic relatime traffic graph v1.png

GRAPH DESCRIPTION
Bridge Cumulative graph, which encompasses wired Ethernet LAN and the wireless network
LAN Displays traffic that passes through the LAN network interface(s) in graph form
WiFi Displays traffic that passes through the WiFi interface in graph form
WAN (Wired) | WAN (WiFi) | Mobile Displays traffic that passes through the current active WAN connection in graph form

Wireless[edit | edit source]

The Realtime Wireless graph displays the wireless radio signal strength, signal noise, average and peak signal levels and the theoretical maximum channel permeability. The graph below the WiFi signal graph displays the Phy Rate for the wireless connection.

The figures below are examples of both Wireless graphs:

Rut850 webui status graphs wireless realtime wireless signal v1.png

Rutxxx webui status graphs wireless realtime wireless phy rate v1.png

Connections[edit | edit source]

The Realtime Connections graph displays currently active network connections with the information about network, protocol, source and destination addresses and transfer speed. The table below the graph displays basic information on active connections.

The figures below are examples of both of the Realtime Connections graph and the corresponding table:

Rutxxx webui status graphs connections realtime connections graph v1.png

Rut850 webui status graphs connections realtime connections list v2.png