RUT900 Powering Options

From Teltonika Networks Wiki
Main Page > RUT Routers > RUT900 > RUT900 Manual > RUT900 Powering Options

This chapter contains information on powering options supported by RUT900 routers.

Power socket

The router has a 4 pin power socket and can be powered by a 9-30 VDC power supply unit (PSU). Refer to the image below for the power socket's pinout information:

Power socket pinout
Trb142 power socket pinout v3.png
No. Description Wire color
1 Power Red
2 Ground Black
3 I/O Green
4 I/O White
.

If you decide not to use the standard 9 VDC wall adapter and want to power the device from a higher voltage (15-30 VDC), please make sure that you choose a power supply of high quality. Some power supplies can produce voltage peaks significantly higher than the declared output voltage, especially during connection and disconnection.

While the device is designed to accept input voltage of up to 30 VDC peaks, high voltage power supplies can harm the device. If you want to use high voltage power supplies it is recommended to also use additional safety equipment to suppress voltage peaks from the power supply.

Passive PoE

The device may also be powered by an Ethernet cable via the LAN1 port:
(Do not use in other ports!)

Networking rut950 manual powering options lan1 v2.jpg

  • The device is NOT COMPLIANT with the IEEE 802.3af-2003 standard: powering the device from an IEEE 802.3af-2003 power supply will damage the device as it is not rated for input voltages of the PoE standard.
  • The device is NOT COMPLIANT with the IEEE 802.3at standard: it cannot power other devices over Ethernet.

RJ45 pinout:
Pin 10/100 mode B, DC on spares T568A Color T568B Color Pins on plug face (socket is reversed)
1 TX+ Poe white green stripe.png
white/green stripe
Poe white orange stripe.png
white/orange stripe
Poe rj45 connector.png
2 TX- Poe solid green.png
green solid
Poe solid orange.png
orange solid
3 RX+ Poe white orange stripe.png
white/orange stripe
Poe white green stripe.png
white/green stripe
4 DC+ 9-30 VDC Poe solid blue.png
blue solid
Poe solid blue.png
blue solid
5 DC+ 9-30 VDC Poe white blue stripe.png
white/blue stripe
Poe white blue stripe.png
white/blue stripe
6 RX- Poe solid orange.png
orange solid
Poe solid green.png
green solid
7 DC- Poe white brown stripe.png
white/brown stripe
Poe white brown stripe.png
white/brown stripe
8 DC- Poe solid brown.png
brown solid
Poe solid brown.png
brown solid

Simultaneous powering

The router can be powered from a power socket and over Ethernet simultaneously. In this case, both PSUs should have similar output voltages. The power socket has higher priority meaning that the device will draw power from the power socket as long as it is available.

When the device is switching from one power source to another it loses power for a fraction of a second and may reboot. The device will function correctly after the reboot.