RUTX09 Data to Server

From Wiki Knowledge Base | Teltonika Networks
Main Page > RUTX Routers > RUTX09 > RUTX09 Manual > RUTX09 WebUI > RUTX09 Data to Server

Summary

Data to Server function provides you with the possibility to set up senders that transfer data collected from Modbus slaves or Bluetooth devices to remote servers.

The information in this page is updated in accordance with the RUTX_R_00.02.01.1 firmware version.

Data senders

To add a new data sender, select protocol, enter the server's address, specify the data sending period and click the Add button:

Networking rutx manual data to server senders v1.png

Data sender settings


When you add a new data sender, you will be redirected to its configuration window. The figure below is an example of that window and the table below provides information on the fields that it contains:

Networking rutx manual data to server sender settings v1.png

Field Value Description
Enabled off | on; default: off Check to enable data sender
Name Default: Name of the data sender. Used for easier data senders management purposes only (optional)
Data source Default: Bluetooth data Source of the data to be sent to server. Available options:
  • Bluetooth data
  • Modbus data
Protocol Default: HTTP(S) Protocol used for sending the data to server. Available options:
  • HTTP(S)
  • MQTT
JSON format Default: {"TS":"%t", "D":"%d","MAC":"%m","DT":"%b"} You can fully customize JSON segment
Segment count Default: 1 Max segment count in one JSON string sent to server. Available options:
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
URL/Host/Connection string Default: URL for HTTP(S); Host for MQTT; Connection string for Azure MQTT
Period Default: 60 Interval for sending the collected data to server (in seconds, 1-86400)
Data filtering Default: All data Choose which data this sender will send to server. Available options:
  • All data
  • By slave ID
  • By slave IP
  • By MAC address
  • By device name
Retry on fail off | on; default: off In case of a failed attempt, retry to send the same data to server later (Retry until successful)
Custom header Default: Allows to add custom headers to the HTTP requests