RUTX10 Network

From Teltonika Networks Wiki
Main Page > RUTX Routers > RUTX10 > RUTX10 Manual > RUTX10 WebUI > RUTX10 Status section > RUTX10 Network

The information in this page is updated in accordance with firmware version RUTX_R_00.07.00.

Summary[edit source]

The Network page contains information related to the device's networking. This chapter is an overview of the Network page in RUTX10 devices.

If you're having trouble finding this page or some of the parameters described here on your device's WebUI, you should turn on "Advanced WebUI" mode. You can do that by clicking the "Basic" button under "Mode", which is located at the top-right corner of the WebUI.

Networking rutx manual webui basic advanced mode.gif


LAN[edit source]

This tab displays information about the device's local network(s). The figure below is an example of the Network window:

Networking rutx manual network lan v1.png


lan information
Name LAN interface name
IP address IP address of the LAN interface
Netmask Netmask of the LAN interface. In a sense, a netmask specifies the size of a network. In other words, it indicates which part of the IP address denotes the network, and which denotes the device
dhcp leases
Hostname Hostname of a LAN client
IP address IP address of a LAN client
MAC address MAC address of a LAN client
Leasetime remaining Remaining lease time for a DHCP client. Active DHCP lease holders will try to renew their DHCP leases after a half of the lease time passes.

Wireless

Networking rutx manual status network wireless.png

Field name Description
SSID The broadcasted SSID (Service Set Identifier) of the wireless network
Wireless MAC The MAC (Media Access Control) address of the access point radio
Band The band defines which frequency used
Signal The signal quality between router's radio and some other device that is connected to the router
Bit rate The maximum possible physical throughput that the router's radio can handle. Bit rate will be shared between router and other possible devices which connect to local Access Point (AP)
Mode Connection mode. Can either be Access Point (AP) or Client. In AP mode others can connect to this router's wireless connection. In client mode router connects to other wireless networks
Encryption The type of WiFi encryption used
Hostname Device's hostname
IP address Shows what IP address leased for device
MAC address Device's MAC (Media Access Control) address
Signal Received Signal Strength Indicator (RSSI). Signal's strength measured in dBm
RX rate The rate at which packets are received from associated interface
TX rate The rate at which packets are sent to associated interface