RUTX11 Spatial Measurements & Weight

From Wiki Knowledge Base | Teltonika Networks
This is the approved revision of this page, as well as being the most recent.
Main Page > RUTX Routers > RUTX11 > RUTX11 Manual > RUTX11 Spatial Measurements & Weight

This page contains spatial measurement and weight information for RUTX11 devices. The drawings provided here are intended to help approximate the size of the devices before installation.

Figures presented below display the device's measurements from several different angles while adding the measurements of various elements (cables, connectors, etc.) that are located on or protruded out of the device. All measurements are specified in millimetres (mm).

Click here to download a PDF file that contains the same measurement info.

Main measurements

H x W x D dimensions for RUTX11:

  • Device housing*:
  • Box:
95 x 115 x 44
355 x 175 x 60

*Housing measurements are presented without antenna connectors and screws; for measurements of other device elements look to the sections below.

Indicative photo

This indicative photo is presented to help you get a better perspective on the size and spatial relations of RUTX11:

photo upcoming

3D view

You can inspect the device's 3D model by downloading one of the following 3D files:

Viewing 3D PDF file


To view and interact with PDF 3D file please follow these steps:

  • Download the file to your computer.
  • Open file with PDF viewing program, for this overview Adobe Acrobat Reader DC version 2020.012.20043 was used. Do not use your browser to open the file, because you will see only blank page.
  • Likely 3D content will be disabled by default, so you will see blank page with informational warning at the top, click on Options and select either to trust the document once or always, choose one according to your preference.
  • Networking opening 3d models adobe warning.png

  • Now you should be able to see and interact with 3D model, for easier navigation please click right mouse button and select Show Model Tree and on left side you should see a list with all parts where you can pick and choose what you want to be displayed on your screen.
  • If Warning message was not displayed please try the following:
    1. Go to Edit > Preferences > 3D & Multimedia and then select the Enable playing 3D content checkbox (for Adobe Acrobat Reader).
    2. If you cannot locate 3D content options, please update your software version.

    If you followed these steps and your application version is sufficient you should be able to fully interact with 3D model of your device, including hiding, rotating, isolating and measuring each separate component, or whole model at once.

    Top view

    The figure below depicts the measurements of RUTX11 and its components as seen from the top:

    Networking rutx11 manual spatial measurements top v2.png

    Right view

    The figure below depicts the measurements of RUTX11 and its components as seen from the right side:

    Networking rutx11 manual spatial measurements right v2.png

    Front view

    The figure below depicts the measurements of RUTX11 and its components as seen from the front panel side:

    Networking rutx11 manual spatial measurements front v2.png

    Rear view

    The figure below depicts the measurements of RUTX11 and its components as seen from the back panel side:

    Networking rutx11 manual spatial measurements rear v2.png

    Mounting space requirements

    The figure below depicts an approximation of the device's dimensions when cables and antennas are attached:

    Networking rutx11 manual spatial measurements mounting v1.png

    DIN rail

    The scheme below depicts protrusion measurements of an attached DIN Rail:

    Networking rutx11 manual spatial measurements din rail v1.png

    Weight

    • Device (housing + PCB):
    • Box:
    • Standard package (device + box + accessories):
    460 g
    81 g
    936 g