RUTXR1 Other

From Teltonika Networks Wiki
Main Page > RUTX Routers > RUTXR1 > RUTXR1 Manual > RUTXR1 WebUI > RUTXR1 Network section > RUTXR1 Other

The information in this page is updated in accordance with firmware version RUTX_R_00.07.07.3.


The Other page is used to to set up UDP Broadcast relay.

This manual page provides an overview of Other page in RUTXR1 devices.

If you're having trouble finding this page or some of the parameters described here on your device's WebUI, you should turn on "Advanced WebUI" mode. You can do that by clicking the "Advanced" button, located at the top of the WebUI.

Networking rutos manual webui basic advanced mode 75.gif

UDP Broadcast Relay

The UDP Broadcast Relay will listen for broadcast traffic on the specified interface port and relay that traffic to the specified interface(s).

Note: UDP Broadcast Relay is additional software that can be installed from the System → Package Manager page.

The Static Lease list is empty by default. To add a new Static Lease click the 'Add' button.

Networking rutos manual other udp broadcast relay add.png

Appears static lease, which should look similar to this:

Networking rutos manual other udp broadcast relay v1.png

Field Value Description
Source interface lan | wan; default: lan The interface from which the traffic will be redirected to.
Port integer [0..655353]; default: none Specify a port which the UDP broadcast relay will listen on for incoming packets to relay.
Destination interface lan | wan; default: none UDP broadcast relay destination interfaces. Open port 137 in firewall so LAN could be reachable from WAN.
Enable off | on; default: off Turns UDP Broadcast Relay on or off.