165
edits
Changes
Mobile Parameters to HTTP Server (view source)
Revision as of 13:04, 6 April 2023
, 13:04, 6 April 2023no edit summary
==Introduction==
==Introduction==
Mobile parameters are needed to measure signal features that can be acquired using
Mobile parameters are needed to measure signal features that can be acquired using
This article provides step-by-step instructions on how to write the script, programs that
This article provides step-by-step instructions on how to write the script, programs that
are required, and how to run it.
are required, and how to run it.
----
* First you want to make sure that you have '''ADVANCED mode''' enabled. This will allow you to choose from a larger variety of settings.
[[File:Networking rutx manual webui basic advanced mode v1.gif|border|class=tlt-border]]
----
==Prerequisites==
For this particular configuration you will need:
* A Gateway or a Router with GSM (RUTX14 is being used in the example)
* 1 SIM card
* 1 PC
* HTTP Server (Hercules)
==Preparation==
* Prepare RUTX14, power up the device, insert the sim card, check that mobile interface is active and working. SIM1, PWR and signal strength indicators should light up.
'''Network -> Interfaces''' should look similar to this:
[[File:Screenshot 1.png|center]]
==Configuration==
===Making a Directory and Script===
'''1.''' Connect to RUTX14 CLI using PUTTY or WEBUI.
'''2.''' Create a new directory for the custom script.
* mkdir /etc/config/scripts
[[File:Screenshot 2.png|center]]
'''3.''' Then create a new .sh file.
*touch /etc/config/scripts/<filename>.sh
[[File:Screenshot 3.png|center]]
'''4.''' To edit the filename, use '''vi <filename>.sh'''. Press '''I'''. To save and exit, '''Press Esc''' then ''':x''' or to exit without saving, '''Press Esc''' then ''':q!'''.
[[File:Screenshot 4.png|center]]
[[File:Screenshot 5.png|center]]
