After this you should be redirected to instance's configuration page which should look similar to this:
After this you should be redirected to instance's configuration page which should look similar to this:
−
[[File:Networking_rutos_manual_modbus_modbus_tcp_over_serial_gateway_configuration_rs232_{{#ifeq:{{#expr: {{{rs232}}} or {{{usb}}}}} |1|1|0}}_v1.png|border|class=tlt-border]]
+
[[File:Networking_rutos_manual_modbus_modbus_tcp_over_serial_gateway_configuration_rs232_{{#ifeq:{{#expr: {{{rs232}}} or {{{usb}}}}} |1|1|0}}_v2.png|border|class=tlt-border]]
<table class="nd-mantable">
<table class="nd-mantable">
Line 1,586:
Line 1,586:
<td>Checks if sent serial message is not disturbed.</td>
<td>Checks if sent serial message is not disturbed.</td>
</tr>{{#ifeq:{{#expr: {{{rs232}}} or {{{usb}}}}} |1|
</tr>{{#ifeq:{{#expr: {{{rs232}}} or {{{usb}}}}} |1|
−
<tr>
+
|}}{{#ifeq: {{{rs485}}} | 1 |
−
<td>Echo</td>
−
<td>off {{!}} on; default: <b>off</b></td>
−
<td>Turns RS232 echo on or off. RS232 echo is a loopback test usually used to check whether the RS232 cable is working properly.</td>
−
</tr>|}}{{#ifeq: {{{rs485}}} | 1 |
<tr>
<tr>
<td><span style="color:blue">RS485:</span> Full Duplex</td>
<td><span style="color:blue">RS485:</span> Full Duplex</td>