Changes

A failover <b>Interface Configuration</b> page is used to configure how the device will determine whether an interface is online or offline. To enter an interface configuration page, click the 'Edit' button next to an interface.

A failover <b>Interface Configuration</b> page is used to configure how the device will determine whether an interface is online or offline. To enter an interface configuration page, click the 'Edit' button next to an interface.

[[File:Networking_rutos_manual_failover_interface_configuration_edit_button_v1.png|border|class=tlt-border]]

[[File:Networking_rutos_manual_failover_interface_configuration_edit_button_v2.png|border|class=tlt-border]]

After this you should be redirected to the configuration page of that interface.

After this you should be redirected to the configuration page of that interface.

[[File:Networking_rutos_manual_failover_interface_configuration.png|border|class=tlt-border]]

[[File:Networking_rutos_manual_failover_interface_configuration_v1.png|border|class=tlt-border]]

<table class="nd-mantable">

<table class="nd-mantable">

However, Load Balancing can be used to increase the speed of multiple connections. For example, when used in a WiFi network, Load Balancing would utilize the resources of multiple WAN interfaces to handle the many various requests of different clients.

However, Load Balancing can be used to increase the speed of multiple connections. For example, when used in a WiFi network, Load Balancing would utilize the resources of multiple WAN interfaces to handle the many various requests of different clients.

Both Load Balancing and Failover cannot be used at the same time. If you wish to select Load Balancing, you can do that in the dropdown located in the top-right corner of the page:

Both Load Balancing and Failover cannot be used at the same time. If you wish to select Load Balancing, you can do that in the dropdown located under 'Mode' section:

[[File:Networking_rutos_manual_failover_load_balancing_select.png|border|class=tlt-border]]

[[File:Networking_rutos_manual_failover_load_balancing_select_v1.png|border|class=tlt-border]]

Below is an example of the Load Balancing page.

Below is an example of the Load Balancing page.

[[File:Networking_rutos_manual_failover_load_balancing_interfaces.png|border|class=tlt-border]]

[[File:Networking_rutos_manual_failover_load_balancing_interfaces_v1.png|border|class=tlt-border]]

When Load Balancing is selected, you can <b>assign ratio values</b> to WAN interfaces. The ratio value represents a percentage of traffic load that will go through an interface. For example, if you set it up like this:

When Load Balancing is selected, you can <b>assign ratio values</b> to WAN interfaces. The ratio value represents a percentage of traffic load that will go through an interface. For example, if you set it up like this: