Wireless Mesh configuration example: Difference between revisions
Wireless Mesh configuration example (view source)
Revision as of 12:06, 4 December 2024
, 4 December→Configuration
| Line 71: | Line 71: | ||
# Make sure '''Enable DHCPv4/v6''' is disabled. | # Make sure '''Enable DHCPv4/v6''' is disabled. | ||
[[File:Disable-DHCP-mesh node.png|border|class=tlt-border|center]] | [[File:Disable-DHCP-mesh node.png|border|class=tlt-border|center]] | ||
---- | |||
===Additional settings=== | |||
If the mesh node needs to have internet access, you can create a static route for it. For that, follow these steps: | |||
# In the WebUI of the mesh node, go to '''Network → Routing → Static Routes'''. | |||
# Click the [[File:Add Button.png]] button to create a new static route under the IPv4 routing section. | |||
# In the route setup, configure the following: Target – 0.0.0.0, IPv4 Netmask – 0.0.0.0, IPv4 Gateway – enter the LAN IP address of the mesh gateway. | |||
[[File:Mesh-node-static-route.png|border|class=tlt-border|center]] | |||
==Testing the configuration== | ==Testing the configuration== | ||