732
edits
Changes
Template:Networking device manual unmanaged switch recovery troubleshooting (view source)
Revision as of 16:31, 24 April 2020
, 16:31, 24 April 2020no edit summary
<dd>{{{name}}} <span style="color:green">green</span> Ethernet port LED is not lighting up (<span style="color:orange">orange</span> LED lit)</dd>
<dd>{{{name}}} <span style="color:green">green</span> Ethernet port LED is not lighting up (<span style="color:orange">orange</span> LED lit)</dd>
<dt>Solution</dt>
<dt>Solution</dt>
<dd>{{{name}}} switch <span style="color:green">green</span> Ethernet port LED indicates Gigabit connection with device. Check if connected device network card support Gigabit speeds or software configuration is not limited to 10/100 Mbps.</dd>
<dd>{{{name}}} switch <span style="color:green">green</span> Ethernet port LED indicates Gigabit connection with device. Check if connected device network card supports Gigabit speeds or software configuration is not limited to 10/100 Mbps.</dd>
</dl>
</dl>
</li>
</li>
==Connected device not powering via PoE==
==Connected device not powering via PoE==
<ol type="I">
<li>
<dl>
<dt>Issue</dt>
<dd>Connected device to {{{name}}} is not powered via PoE</dd>
<dt>Solution I</dt>
<dd>Check if connected device supports 802.3af and/or 802.3at PoE standard(s)</dd>
<dt>Solution II</dt>
<dd>Check if {{{name}}} switch is powered with PSU, which outputs 44 VDC or higher voltages and can provide at least 2 W + connected needed power</dd>
<!--- <dt>Solution III</dt>
<dd>If using 10/100 Mbps connection, make sure that your cable has connected all wiring pairs</dd> --->
</dl>
</li>
<li>
<dl>
<dt>Issue</dt>
<dd>Connected device to {{{name}}} is not powered via PoE</dd>
<dt>Solution I</dt>
<dd>Check if connected device supports 802.3af and/or 802.3at PoE standard(s)</dd>
<dt>Solution II</dt>
<dd>Check if {{{name}}} switch is powered with PSU, which outputs 44 VDC or higher voltages and can provide at least 2 W + connected needed power</dd>
<!--- <dt>Solution III</dt>
<dd>If using 10/100 Mbps connection, make sure that your cable has connected all wiring pairs</dd> --->
</dl>
</li>
</ol>
==RMA==
==RMA==
