64
edits
Changes
DHCP Relay configuration example (view source)
Revision as of 11:50, 2 February 2022
, 11:50, 2 February 2022no edit summary
2. Modify Enable-DHCP-renew firewall rule in '''Network -> Firewall -> Traffic rules''' to additionally allow destination port 67.
2. Modify Enable-DHCP-renew firewall rule in '''Network -> Firewall -> Traffic rules''' to additionally allow destination port 67.
[[File:Networking_rutx_manual_firewall_trafic_rules_configuration_for_dhcp_relay_v2.png|border|class=tlt-border]]
[[File:Networking_rutx_manual_firewall_trafic_rules_configuration_for_dhcp_relay_v1.png|border|class=tlt-border]]
3. DHCP Server must be able to assign addresses from 192.168.2.0/24 IP address pool. If DHCP Server is a Teltonika device running RUTOS then you can add this address pool via router's CLI by running command:
3. DHCP Server must be able to assign addresses from 192.168.2.0/24 IP address pool. If DHCP Server is a Teltonika device running RUTOS then you can add this address pool via router's CLI by running command:
Static route can be added via '''Network -> Routing -> Static IPv4 routes'''.
Static route can be added via '''Network -> Routing -> Static IPv4 routes'''.
[[File:Networking_rutx_manual_routing_ip4_static_routes_configuration_v2.png|border|class=tlt-border]]
[[File:Networking_rutx_manual_routing_ip4_static_routes_configuration_v1.png|border|class=tlt-border]]
* Interface: Network interface where DHCP Relay resides
* Interface: Network interface where DHCP Relay resides
