Changes

     <li>An interface configuration window will show up. In '''General Setup''' tab '''Enable''' interface, select Mode as '''Mesh''', and enter Mesh ID. '''Mesh ID Must be identical on all devices'''.</li>

     <li>An interface configuration window will show up. In '''General Setup''' tab '''Enable''' interface, select Mode as '''Mesh''', and enter Mesh ID. '''Mesh ID Must be identical on all devices'''.</li>

     <li>In '''Wireless Security''' tab select Encryption '''WPA3 – SAE''' and enter the Password. '''The password must match on all devices'''.</li>

     <li>In '''Wireless Security''' tab select Encryption '''WPA3 – SAE''' and enter the Password. '''The password must match on all devices'''.</li>

     <li>In '''Advanced Settings''' tab enable Forward mesh peer traffic and set RSSI threshold for joining to -80. Leave the rest as set by default.</li>

     <li>In '''Advanced Settings''' tab enable Forward mesh peer traffic and set RSSI threshold for joining to '''-80'''. Leave the rest as set by default.</li>

</ol>

</ol>

[[File:Networking_rutx11_configuration_example_wireless_mesh_mesh_common_configuration_1_v2.png|border|class=tlt-border]]

[[File:Networking_rutx11_configuration_example_wireless_mesh_mesh_common_configuration_1_v2.png|border|class=tlt-border]]

*Navigate to '''Network''' → '''Wireless'''. The mesh interface, in this case "1", shows the number of connected mesh nodes, which is 2.

*Navigate to '''Network''' → '''Wireless'''. The mesh interface, in this case "1", shows the number of connected mesh nodes, which is 2.

[[File:Networking rutx11 configuration example wireless mesh test 1 v2.png|border|class=tlt-border]]  

[[File:Networking rutx11 configuration example wireless mesh test 1 v2.png|border|class=tlt-border]]  

*A list of IP addresses leased by mesh gateway can be viewed by going to Status → Network → LAN. In the screenshot given IP addresses can be seen given to the two RUT routers as well as a device, connected to the access point.

*A list of IP addresses leased by mesh gateway can be viewed by going to '''Status''' → '''Network''' → '''LAN'''. In the screenshot given IP addresses can be seen given to the two RUT routers as well as a device, connected to the access point.

[[File:Networking rutx11 configuration example wireless mesh test 2 v2.png|border|class=tlt-border]]

[[File:Networking rutx11 configuration example wireless mesh test 2 v2.png|border|class=tlt-border]]

*Those IPs can be pinged from the mesh gateway despite the fact that there is no wired or mobile connection between the mesh nodes.  

*Those IPs can be pinged from the mesh gateway despite the fact that there is no wired or mobile connection between the mesh nodes.