|
|
| Line 123: |
Line 123: |
| |Härmed intygar TELTONIKA NETWORKS att denna RUTX09 är i överensstämmelse med de väsentliga egenskapskrav och övriga relevanta bestämmelser som framgår av direktiv 2014/53/EU | | |Härmed intygar TELTONIKA NETWORKS att denna RUTX09 är i överensstämmelse med de väsentliga egenskapskrav och övriga relevanta bestämmelser som framgår av direktiv 2014/53/EU |
| |} | | |} |
|
| |
| '''FCC'''
| |
|
| |
| This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
| |
|
| |
| # This device may not cause harmful interference.
| |
| # This device must accept any interference received, including interference that may cause undesired operation.
| |
|
| |
|
| |
| This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
| |
| * Reorient or relocate the receiving antenna.
| |
| * Increase the separation between the equipment and receiver.
| |
| * Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
| |
| * Consult the dealer or an experienced radio/TV technician for help.
| |
|
| |
| '''FCC Caution:''' Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
| |
|
| |
|
| |
| '''ISED Canada'''
| |
|
| |
| This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada's license-exempt RSS(s). Operation is subject to the following two conditions:
| |
| # This device may not cause interference;
| |
| # This device must accept any interference, including interference that may cause undesired operation of the device.
| |
|
| |
| L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
| |
| # L'appareil ne doit pas produire de brouillage;
| |
| # L'appareil doit accepter tout brouillage radioélectrique subi, mźme si le brouillage est.
| |
|
| |
|
| |
|
| |
|
| '''NOM''' | | '''NOM''' |
| Line 175: |
Line 146: |
| ---- | | ---- |
| This device meets the official requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by authorized agencies. The device must be used with a minimum separation of 20 cm from a person’s body to ensure compliance with RF exposure guidelines. Failure to observe these instructions could result in your RF exposure exceeding the applicable limits. | | This device meets the official requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by authorized agencies. The device must be used with a minimum separation of 20 cm from a person’s body to ensure compliance with RF exposure guidelines. Failure to observe these instructions could result in your RF exposure exceeding the applicable limits. |
|
| |
|
| |
|
| External antennas used with RUTX09 must be installed to provide a distance of at least 20 cm from any people and must not be co-located or operated in conjunction with any other antenna or transmitter. | | External antennas used with RUTX09 must be installed to provide a distance of at least 20 cm from any people and must not be co-located or operated in conjunction with any other antenna or transmitter. |
|
| |
|
| |
|
| Any external antenna gain must meet RF exposure and maximum radiated output power limits of the applicable rule section. | | Any external antenna gain must meet RF exposure and maximum radiated output power limits of the applicable rule section. |
