Stunnel configuration example using Telnet: Difference between revisions
Stunnel configuration example using Telnet (view source)
Revision as of 01:50, 24 November 2022
, 24 November 2022no edit summary
No edit summary |
No edit summary |
||
| Line 80: | Line 80: | ||
Once the application is installed, open stunnel, go to configuration and select edit configuration. Remove all the content and paste as below: | Once the application is installed, open stunnel, go to configuration and select edit configuration. Remove all the content and paste as below: | ||
; Example TLS client mode services | ; Example TLS client mode services | ||
[my-stunnel-conf] | [my-stunnel-conf] | ||
Client = yes | Client = yes | ||
Accept = 127.0.0.1:23 | Accept = 127.0.0.1:23 | ||
Connect =84.15.X.X:2030 | Connect =84.15.X.X:2030 | ||
Cert = ca-cert1.pem | Cert = ca-cert1.pem | ||
Connect IP depends on your configuration and write them accordingly. Here in this example, it is as above. | Connect IP depends on your configuration and write them accordingly. Here in this example, it is as above. | ||