TAP100 Realtime Data

From Teltonika Networks Wiki
Main Page > TAP Access Points > TAP100 > TAP100 Manual > TAP100 WebUI > TAP100 Status section > TAP100 Realtime Data

The information in this page is updated in accordance with firmware version TAP100_R_00.07.07.1.


The Realtime Data page contains various graphs that display various statistical data changes in real time.

This chapter of the user manual provides an overview of the Realtime Data page for TAP100 devices.


The Realtime Load section displays a tri-graph that illustrates average CPU load values in real time. The graph consists out of three color coded graphs, each one corresponding to the average CPU load over 1 (red), 5 (orange) and 15 (yellow) most recent minutes.

The figure below is an example of the Realtime Load graph:

Networking rutx manual realtime graphs load v2.png


The Realtime Traffic graphs provide users with the possibility to monitor average inbound and outbound traffic over the course of 3 minutes. Each new measurement is taken every 3 seconds. The graphs consist out of two color coded graphs: the green graph shows the outbound traffic, the blue graph shows the inbound traffic. Although not graphed, the page also displays peak loads and averages of inbound and outbound traffic.

The figure below is an example of the Realtime traffic graph:
Networking tap100 manual realtime graphs traffic ethernet v2.png

Graph Description
RUT_XXXX_2G Displays traffic that passes through the wifi connection in graph form


The Realtime Wireless graph displays the wireless radio signal strength, signal noise, average and peak signal levels.

The figure below is example of Wireless graph:

Networking tap100 manual realtime graphs wireless v2.png