Template:Networking rut hardware examples relay to open collector output

From Teltonika Networks Wiki
This is the approved revision of this page, as well as being the most recent.

This page provides an example on how to connect a relay to a {{{name}}} device's open collector output.

[[File:Networking_{{{name}}}_hardware_examples_relay_to_open_collector_output.png]]

Note: if you use different power supplies for {{{name}}} and relay, their ground wires must be connected together.

Note: some relays have internal protection diode D. When connecting such relay you mustn’t mix up coil contacts. If you mix up the relay coil contacts you might cause permanent damage to the open collector output.

See also[edit source]

  • [[{{{name}}} Input/Output|Input/Output Manual page]]
  • [[{{{name}}} Front & Back Panels|Power connector pinout]]

[[Category:{{{name}}} Hardware Application Examples]]