WebUI and CLI access IP and Ports that must be accessible

From Teltonika Networks Wiki
This is the approved revision of this page, as well as being the most recent.
Main Page > IoT Platforms > RMS > RMS FAQ > WebUI and CLI access IP and Ports that must be accessible

In order for WebUI and CLI access functionalities to work, the Router must be able to have access to services with the following IP and Ports*:

  • 18.196.62.30 : 15009, 15010
  • 18.192.27.240 : 20022, 20080, 23389

* although these are currently in use ports, it is recommended to unblock all ports on specified IP addresses.

In most cases, access to these IP addresses shall not be an issue as usually none of the outgoing traffic blocked.

However, where ISP blocks all non-standard ports, or the SIM card is in a Private APN network/setup, you will have to inquire your ISP to allow the mentioned IP and Ports to be made available.