Difference between revisions of "RUTX08 LEDs"
From Teltonika Networks Wiki
(Created page with "{{Template: Networking_rutos_manual_leds <!------------------------DEVICE-----------------------> | name = RUTX08 | series = RUTX <!----------------------SEPAR...") |
|||
| (4 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{Template: Networking_rutos_manual_leds | {{Template: Networking_rutos_manual_leds | ||
<!------------------------DEVICE-----------------------> | <!------------------------DEVICE-----------------------> | ||
| − | | name | + | | name = RUTX08 |
| − | | series | + | | series = RUTX |
<!----------------------SEPARATORS---------------------> | <!----------------------SEPARATORS---------------------> | ||
| − | | eth_leds | + | | 2g = 0 <!-- 1 has 2G; 0 doesn't have 2G --> |
| − | | mobile | + | | eth = 1 <!-- 1 has ETH; 0 doesn't have ETH --> |
| − | | mobile_leds | + | | eth_leds = 2 <!-- 1 for green; 2 for green & orange --> |
| − | | power_leds | + | | mobile = 0 <!-- 1 has mobile; 0 doesn't have mobile --> |
| − | | wan | + | | mobile_leds = <!-- number of mobile signal strength type LEDs --> |
| − | | wifi | + | | power_leds = 1 <!-- number of power LEDs --> |
| + | | wan = 0 <!-- 1 has WAN type LEDs; 0 doesn't have WAN type LEDs --> | ||
| + | | wifi = 0 <!-- 1 has WiFi band LEDs; 0 doesn't have WiFi band LEDs --> | ||
}} | }} | ||
Latest revision as of 14:58, 31 August 2020
Main Page > RUTX Routers > RUTX08 > RUTX08 Manual > RUTX08 LEDsThis page contains information the different types of LEDs and their behaviour on a RUTX08 device.
Power LED
The power LED is located on the bottom left corner of the front panel, just under the power connector.
It indicates whether the device is powered on or not.
| State | Description |
|---|---|
| LED turned on | Device is powered on. |
| LED turned off | Device is not powered on. |
Ethernet port LEDs
There are two LEDs located at the top of each Ethernet port.
They provide information on the current states of the Ethernet ports. Each port has two LEDs:
- Orange - 10/100 Mbps connection
- Green- 1000 Mbps connection
Below is an explanation on the behaviours of green and orange LEDs.
| State | Description |
|---|---|
| LED on | A data connection on the port is operational (cable plugged in, end device visible, no data is being transferred). |
| LED off | No data connection on the port is operational (no cable, bad cable or end device not visible for some other reason (such as damaged network card). |
| LED blinking | Connection established and data is being transferred over this port. |
