51
edits
Changes
Modbus data to server via MQTT TLS (view source)
Revision as of 14:25, 6 September 2023
, 14:25, 6 September 2023no edit summary
When installation of '''modRSsim2''' application has been successfully completed, open the application, and apply the following configuration.
When installation of '''modRSsim2''' application has been successfully completed, open the application, and apply the following configuration.
# # Select Protocol '''“MODBUS TCP/IP”.'''
# Select Protocol '''“MODBUS TCP/IP”.'''
# # Click '''“Setup the communication Serial or TCP/IP port”''' button.
# Click '''“Setup the communication Serial or TCP/IP port”''' button.
[[File:ModRSim2 test1.png|left|thumb]]
# # Take note of the '''“Port”'''
# Take note of the '''“Port”'''
# # Click '''“OK”''' to close the menu
# Click '''“OK”''' to close the menu
# # Configure the static IP address of the Windows 10 Computer to match the one in the topology.
# Configure the static IP address of the Windows 10 Computer to match the one in the topology.
# # Change some values in different register of the '''modRSsim2''' application as shown below:
# Change some values in different register of the '''modRSsim2''' application as shown below:
===Configuring Modbus TCP/IP Master===
===Configuring Modbus TCP/IP Master===