Bootloader menu
Main Page > FAQ > Troubleshooting & Recovery > Bootloader menu
The bootloader menu is a special router state used as a recovery tool in case the router becomes inaccessible even after a factory reset. It can be used to upgrade the router's firmware or bootloader version.
How to
- In order to place the router into the bootloader menu state, follow these steps:
- Unplug all cables from the router
- Plug in one Ethernet cable for your computer into any LAN port
- Press and hold the reset button
- While holding the reset button, plug the power cable into the router. After you plug in the power cable, continue holding the button for another 4 seconds
- Release the reset button
- If you followed all the steps correctly, Ethernet LEDs should start lighting up and turning OFF one after the other, from WAN port to LAN1 port. This means that the router is in the bootloader menu state. If that is not the case, repeat the steps again.
- Regardless of what the router's IP address was before, the IP address of the router when it's in the bootloader menu state is always 192.168.1.1.
So in order to reach the router, you'll have to set up a static IP address that's in the 192.168.1.0/24 network (fox instance, 192.168.1.2) on your computer. Instructions are provided below:
- When set your computer's IP, you should be able to reach the router's HTTP server. The address depends on what you wish to upgrade:
- Bootloader upgrade URL: 192.168.1.1/uboot.html
- Firmware upgrade URL: 192.168.1.1/index.html
See also
- Firmware/bootloader file downloads:
- Detailed instructions:
- RUT9xx
- RUT2xx