...After unexpected shut down''' sub-type. This section is an overview of all other Event type and sub-types.
...figuration are applied. For example, whenever a switch from using Wired as main WAN to backup WAN occurs, Wireless is added as a Backup WAN, Health monitor
66 KB (9,365 words) - 10:37, 10 December 2020
...After unexpected shut down''' sub-type. This section is an overview of all other Event type and sub-types.
...figuration are applied. For example, whenever a switch from using Wired as main WAN to backup WAN occurs, Wireless is added as a Backup WAN, Health monitor
67 KB (9,677 words) - 16:05, 5 July 2021
...After unexpected shut down''' sub-type. This section is an overview of all other Event type and sub-types.
...figuration are applied. For example, whenever a switch from using Wired as main WAN to backup WAN occurs, Wireless is added as a Backup WAN, Health monitor
67 KB (9,689 words) - 12:24, 24 October 2023
...After unexpected shut down''' sub-type. This section is an overview of all other Event type and sub-types.
...figuration are applied. For example, whenever a switch from using Wired as main WAN to backup WAN occurs, Wireless is added as a Backup WAN, Health monitor
76 KB (10,825 words) - 10:54, 19 July 2021
...After unexpected shut down''' sub-type. This section is an overview of all other Event type and sub-types.
...figuration are applied. For example, whenever a switch from using Wired as main WAN to backup WAN occurs, Wireless is added as a Backup WAN, Health monitor
76 KB (10,932 words) - 12:37, 24 October 2023
...After unexpected shut down''' sub-type. This section is an overview of all other Event type and sub-types.
...figuration are applied. For example, whenever a switch from using Wired as main WAN to backup WAN occurs, Wireless is added as a Backup WAN, Health monitor
77 KB (11,152 words) - 12:38, 24 October 2023
...mation on <b>network interface configuration</b>. There are {{{no_of_if}}} main types of interfaces on the device:
...s that go along with each protocol. If <b>None</b> protocol is chosen, all other interface settings will be ignored. The following sections are different fo
53 KB (7,859 words) - 12:08, 24 October 2023
...are routers in the same BGP Peer Group that can redistribute routes among other BGP Peers. Below is an example of the BGP Peers section, which is empty by
...that use the BGP protocol to dynamically redistribute routes among peers (other routers). The figure below is an example of the BGP Peer Groups section, wh
54 KB (8,054 words) - 10:40, 17 April 2024
*RUT240 or any other Teltonika Networks router running legacy firmware
...Fi''' it’s possible to change the name of WiFi along with a passphrase or other operation settings. After the changes have been made, proceed to the next s
28 KB (4,403 words) - 16:44, 8 February 2022
...Internet. VPNs can serve to achieve many different goals, but some of its main purposes are:
...side (client and server) of the connection. If one side uses <i>0</i>, the other side should use <i>1</i>, or both sides should omit the parameter altogethe
39 KB (5,911 words) - 12:09, 24 October 2023
...Internet. VPNs can serve to achieve many different goals, but some of its main purposes are:
...side (client and server) of the connection. If one side uses <i>0</i>, the other side should use <i>1</i>, or both sides should omit the parameter altogethe
40 KB (5,947 words) - 12:25, 24 October 2023
...WAN – Mobile and Wi-Fi. You can also setup backup WAN options in case your main connection goes down.
...from the left). Above is an example of a configuration that uses mobile as Main WAN and Wi-Fi as Backup WAN.
13 KB (2,042 words) - 11:38, 7 May 2020
...<li><b>Hub</b> - the central instance of DMVPN that connects other peers (spokes) into single network. There is no need to reconfigure the hub
<td>Main | Aggressive; default: <b>Main</b></td>
7 KB (1,013 words) - 15:43, 8 July 2019
* Main gateway with WAN access (Any RUTOS router. RUTXR1 is used in this example)
...s WebUI, navigate to the '''Network → Interfaces → Edit LAN''' page. Enter main gateway's IP address and save. We will leave it default (192.168.1.1) for t
4 KB (662 words) - 14:50, 2 August 2023
The <b>Mobile Configuration</b> section is used to configure main SIM card parameters. Refer to the figure and table below for information on
...re you to enter the APN just to complete the registration to a network. In other cases an APN is used to get special parameters from the operator (e.g., a [
20 KB (3,283 words) - 08:44, 9 June 2020
** Removed enable option from AVL main rule
** Added hints in "Multiple Access Points" page and a redirect to main wireless page after saving
51 KB (7,357 words) - 10:34, 24 May 2023
...ber of other channels. Choosing WiFi channels that are far apart from each other may also prove to increase performance when using more than one AP on the d
...th 4 adjacent channels on each side. Therefore, it might overlap with many other Access Points operating at similar frequencies. If that is the case, the ro
16 KB (2,345 words) - 12:25, 24 October 2023
...ber of other channels. Choosing WiFi channels that are far apart from each other may also prove to increase performance when using more than one AP on the d
...th 4 adjacent channels on each side. Therefore, it might overlap with many other Access Points operating at similar frequencies. If that is the case, the ro
16 KB (2,309 words) - 12:30, 24 October 2023
...mation on <b>network interface configuration</b>. There are {{{no_of_if}}} main types of interfaces on the device:
...s that go along with each protocol. If <b>None</b> protocol is chosen, all other interface settings will be ignored. The following sections are different fo
44 KB (6,505 words) - 15:28, 8 April 2024
...mation on <b>network interface configuration</b>. There are {{{no_of_if}}} main types of interfaces on the device:
...s that go along with each protocol. If <b>None</b> protocol is chosen, all other interface settings will be ignored. The following sections are different fo
45 KB (6,587 words) - 16:19, 6 May 2024