TSW010 Powering Options

From Teltonika Networks Wiki
Main Page > TSW Switches > TSW010 > TSW010 Manual > TSW010 Powering Options

This chapter contains information on powering options supported by TSW010 switch.

The switch has a 2 pin power socket and can be powered by a 7-30 VDC power supply unit (PSU). Refer to the image below for the power socket's pinout information:

Power socket

2 pin power socket

No. Description Wire color
TSW0 power socket pinout.png
1 Power Red
2 Ground Black



Passive PoE

The device may also be powered by an Ethernet cable via the LAN1 port:
(Do not use in other ports!)

Networking tsw114 manual powering options lan1.png

  • The device is NOT COMPLIANT with the IEEE 802.3af-2003 standard: powering the device from an IEEE 802.3af-2003 power supply will damage the device as it is not rated for input voltages of the PoE standard.
  • The device is NOT COMPLIANT with the IEEE 802.3at standard: it cannot power other devices over Ethernet.

RJ45 pinout:
Pin 10/100 mode B, DC on spares T568A Color T568B Color Pins on plug face (socket is reversed)
1 TX+ Poe white green stripe.png
white/green stripe
Poe white orange stripe.png
white/orange stripe
Poe rj45 connector.png
2 TX- Poe solid green.png
green solid
Poe solid orange.png
orange solid
3 RX+ Poe white orange stripe.png
white/orange stripe
Poe white green stripe.png
white/green stripe
4 DC+ 9-30 VDC Poe solid blue.png
blue solid
Poe solid blue.png
blue solid
5 DC+ 9-30 VDC Poe white blue stripe.png
white/blue stripe
Poe white blue stripe.png
white/blue stripe
6 RX- Poe solid orange.png
orange solid
Poe solid green.png
green solid
7 DC- Poe white brown stripe.png
white/brown stripe
Poe white brown stripe.png
white/brown stripe
8 DC- Poe solid brown.png
brown solid
Poe solid brown.png
brown solid