Line 27: |
Line 27: |
| | configurableio = {{{configurableio}}} | | | configurableio = {{{configurableio}}} |
| | input_volts = {{{input_volts}}} | | | input_volts = {{{input_volts}}} |
− | }}{{#ifeq: {{{name}}} | TRB141 | | + | }}{{#switch: {{{name}}} |
− | <h3>Input/Output Connector Pinout</h3> | + | | TRB141 =<h3>Input/Output Connector Pinout</h3> |
| ---- | | ---- |
| [[File:Networking_trb141_manual_input_output_input_output_connector_pinout.png]] | | [[File:Networking_trb141_manual_input_output_input_output_connector_pinout.png]] |
Line 52: |
Line 52: |
| <li><b>1W</b> - 1-Wire protocol input/output.</li> | | <li><b>1W</b> - 1-Wire protocol input/output.</li> |
| <li><b>⏚</b> - GND contact.</li> | | <li><b>⏚</b> - GND contact.</li> |
− | </ul>|}} | + | </ul> |
| + | | RUT955|RUT956 =<h3>Input/Output Connector Pinout</h3> |
| + | ---- |
| + | <ul> |
| + | <li>Digital input (DIN1): Logic low 0 - 1.2 V; Logic high 1.8 - 3 V</li> |
| + | <li>Digital galvanically isolated input (DIN2): 0 - 30 V</li> |
| + | <li>Analog input (voltage mode): 0 – 24 V<span class="asterisk">*</span></li> |
| + | <li>Analog input (current mode): up to 20 mA (commonly used with 4-20 mA standard sensors)</li> |
| + | <li>Digital open collector (OC) output: 30 V, 250 mA</li> |
| + | <li>SPST relay output: 24 V, 4 A</li> |
| + | </ul> |
| + | ---- |
| + | <span class="asterisk">*</span> The deviation from the actual input voltage and the voltage measured by the device is dependent on the input voltage value: |
| + | |
| + | <ul> |
| + | <li>'''≥ 1.5 V''' - the deviation is about ± 10 % and gets lower when the input voltage increases towards 5 V</li> |
| + | <li>'''≥ 5 V''' - the deviation does not exceed ± 3 %</li> |
| + | <li>'''≥ 9 V''' - the deviation does not exceed ± 2 %</li> |
| + | </ul> |
| + | |
| + | <b>Additional note</b>: the deviation values specified above are applicable in temperatures of < 50 °C. Under higher temperatures the deviation values become considerably higher. |
| + | }} |
| | | |
| ==Status== | | ==Status== |