9,312
edits
Changes
Template:Networking rutos manual input output (view source)
Revision as of 14:13, 27 January 2022
, 14:13, 27 January 2022→Physical characteristics and I/O pin mapping
| configurableio = {{{configurableio}}}
| configurableio = {{{configurableio}}}
| input_volts = {{{input_volts}}}
| input_volts = {{{input_volts}}}
}}{{#ifeq: {{{name}}} | TRB141 |
}}{{#switch: {{{name}}}
<h3>Input/Output Connector Pinout</h3>
| TRB141 =<h3>Input/Output Connector Pinout</h3>
----
----
[[File:Networking_trb141_manual_input_output_input_output_connector_pinout.png]]
[[File:Networking_trb141_manual_input_output_input_output_connector_pinout.png]]
<li><b>1W</b> - 1-Wire protocol input/output.</li>
<li><b>1W</b> - 1-Wire protocol input/output.</li>
<li><b>⏚</b> - GND contact.</li>
<li><b>⏚</b> - GND contact.</li>
</ul>|}}
</ul>
| RUT955|RUT956 =<h3>Input/Output Connector Pinout</h3>
----
<ul>
<li>Digital input (DIN1): Logic low 0 - 1.2 V; Logic high 1.8 - 3 V</li>
<li>Digital galvanically isolated input (DIN2): 0 - 30 V</li>
<li>Analog input (voltage mode): 0 – 24 V<span class="asterisk">*</span></li>
<li>Analog input (current mode): up to 20 mA (commonly used with 4-20 mA standard sensors)</li>
<li>Digital open collector (OC) output: 30 V, 250 mA</li>
<li>SPST relay output: 24 V, 4 A</li>
</ul>
----
<span class="asterisk">*</span> The deviation from the actual input voltage and the voltage measured by the device is dependent on the input voltage value:
<ul>
<li>'''≥ 1.5 V''' - the deviation is about ± 10 % and gets lower when the input voltage increases towards 5 V</li>
<li>'''≥ 5 V''' - the deviation does not exceed ± 3 %</li>
<li>'''≥ 9 V''' - the deviation does not exceed ± 2 %</li>
</ul>
<b>Additional note</b>: the deviation values specified above are applicable in temperatures of < 50 °C. Under higher temperatures the deviation values become considerably higher.
}}
==Status==
==Status==
