RUTX09 Network

From Wiki Knowledge Base | Teltonika Networks
Main Page > RUTX Routers > RUTX09 > RUTX09 Manual > RUTX09 WebUI > RUTX09 Status > RUTX09 Network

Summary

The Network page contains information related to the device's networking features. This chapter is an overview of the Network page in RUTX09 routers.

LAN

The LAN tab displays information about the device's local network(s). The figure below is an example of the LAN tab:


lan information
Name LAN interface name
IP address IP address of the LAN interface
Netmask Netmask of the LAN interface. In a sense, a netmask specifies the size of a network. In other words, it indicates which part of the IP address denotes the network, and which denotes the device
dhcp leases
Hostname Hostname of a LAN client
IP address IP address of a LAN client
MAC address MAC address of a LAN client
Leasetime remaining Remaining lease time for a DHCP client. Active DHCP lease holders will try to renew their DHCP leases after a half of the lease time passes.

Mobile

The Mobile tab displays information about the mobile connection. The figure below is an example of the Mobile tab: Networking rutx manual network mobile v2.png

field name description
Sim card slot in useShows which sim card slot is currently in use
IMEI The IMEI (International Mobile Equipment Identity) is a unique 15 decimal digit number used to identify mobile modules. GSM network operators use the IMEI to identify devices in their networks
SIM card state The current SIM card state. Possible values are:
  • Inserted - SIM card is inserted and ready to be used
  • Not inserted - SIM card is not inserted
  • Unknown - unable to obtain SIM card state value. Possible communication issue between the the device and the modem
IMSI The IMSI (international mobile subscriber identity) is a unique 15 decimal digit (or less) number used to identify the user of a cellular network
ICCID SIM card's ICCID - a unique serial number used to identify the SIM chip
Operator Network operator's name
Operator state Shows whether the network has currently indicated the registration of the mobile device. Possible values are:
  • Unregistered - not registered to a network and the device is not currently searching for a new operator to register to
  • Registered (home) - registered, home network
  • Searching - not registered to a network, but the device is currently searching for a new operator to register to
  • Network denied - registration to network denied by operator
  • Unknown - operator state is currently unknown
  • Registered (roaming) - registered to network, roaming conditions
Cell ID The ID of the cell that the modem is currently connected to
Data connection state Indicates whether the device has a mobile data connection or not
Connection type Mobile connection connection type. Possible values are:
  • 3G: 3G (WCDMA), 3G (HSDPA), 3G (HSUPA), 3G (HSPA), 3G (HSPA+), 3G (DC-HSPA+), 3G (HSDPA+HSUPA), UMTS
  • 4G: 4G (LTE)
  • N/A - not possible to determine at the moment
Signal strength Received signal strength indicator (RSSI) measured in dBm. Values closer to 0 indicate a better signal strength
Carrier AggregationLTE Advanced Carrier Aggregation, CA, is one of the key techniques used to enable the very high data rates of 4G to be achieved.

By combining more than one carrier together, either in the same or different bands it is possible to increase the bandwidth available and in this way increase the capacity of the link.

Connected bandCurrently used frequency band. For more information on supported frequency bands,[[RUTX09 supported frequency bands|click here]]
RSRPReference signal received power, measured in dBm. Values closer to 0 indicate better signal strength
RSRQReference signal received quality, measured in dB. Values closer to 0 indicate a better rate of information transfer
SINRSignal-to-interference-plus-noise ratio, measured in dB. Higher values indicate a better rate of information transfer
Bytes received Amount of data received through the mobile interface
Bytes sent Amount of data sent through the mobile interface
Restart Modem Restarts the devices module