Jump to content

Wireless Mesh configuration example: Difference between revisions

Line 64: Line 64:
===Mesh nodes===
===Mesh nodes===
In order to avoid conflicts, each node router needs to be leased their LAN IP by mesh gateway. These settings should also be set after configuring access and mesh points settings, as, otherwise, access to the router will be lost. The configuration is as follows:   
In order to avoid conflicts, each node router needs to be leased their LAN IP by mesh gateway. These settings should also be set after configuring access and mesh points settings, as, otherwise, access to the router will be lost. The configuration is as follows:   
# Access router‘s WebUI. Navigate to '''Network''' → '''Interfaces'''.</li>
# Access router‘s WebUI. Navigate to '''Network''' → '''LAN'''.
# Press pencil icon on the right of the LAN interface.</li>
# Press [[File:Pencil2.png]] icon on the right of the LAN interface.
# Change Protocol to '''DHCP'''.</li> 
# Make sure '''Enable DHCPv4''' is enabled.
[[File:Networking_rutx11_configuration_example_wireless_mesh_mesh_node_configuration_1_v2.png|border|class=tlt-border]]
[[File:Enable_DHCPv4.png|border|class=tlt-border|center]]
[[File:Networking_rutx11_configuration_example_wireless_mesh_mesh_node_configuration_2_v2.png|border|class=tlt-border]]
 
==Testing the configuration==
==Testing the configuration==
There are several ways to check the connection.  
There are several ways to check the connection.